Hello everyone,
I split an image into 3 parts and then bent these parts.
This has somehow introduced a weird issue: the picture parts tend to update to the original non-split picture. See the figures below.
What am I doing wrong?
Original picture:
Split and bent picture:
After a while the picture parts tend to transform to the original picture.
Thank you for you help!
Emmanuel
Hi Emmanuel - are you using ShrinkTrimmedSrf or Shrink=Yes in Split?
-Pascal
Hi Pascal, thank you for your reply.
I used Split with Shrink=No.
Emmanuel
Hi Emmanuel - please, if possible, please post a file with the image and the initially bent, but not split, surface, or send to tech@mcneel.com with a link back here in your comments.
-Pascal
Hi Pascal, thank you again, I will send the file to tech@mcneel.com.
Emmanuel
what if you don’t split the image?
Hi Diego - The surfaces were being shrunk by the deformation process - I proposed a workflow where “PreserveStructure=Yes” could be used so this does not happen - I do not know if it was useful in this case.
-Pascal
Hi Pascal, I often bent pictureframes with no problem but I never tried with splitted ones. I will check it
Hi Diego - if you split and do not preserve structure, the output of Bend or Flow is always shrunk, as far as I can see.
-Pascal
hm! Can you send me that?
-Pascal
Ah, ok. Odd though…
-Pascal
