Only snapping to ground plane

Hello,

Whenever i try to snap an object i can only snap to the ground plane. If i try to snap a line to an object anywhere above the ground a white line appears and snaps to the ground directly below where i am trying to snap to. This is only happening in the perspective viewport. Sorry if i am explaining this badly, i have attached a image to help

Im not sure if this is relevant but no matter where i move the cursor in any of the viewports the z value at the bottom of the screen stays at 0.

Thank you in advance for any help,

Tadhg

@Tadhg, you likely have “Project” snap enabled. See below where to turn it off.

c.

1 Like

@clement Thanks so much :slight_smile:

Thanks so much! I’v eback on Rhino after a year away and found the same problem.