Lining Grasshopper/Lunchbox Panel Solids to the Inside of Model

Grasshopper
1

Hi,

I was wondering if I could get some help with my grasshopper script/rhino model. I have currently created solid panels for my model using lunchbox panels and entwine.

script
script1672×597 129 KB

Inkedskin_LI
Inkedskin_LI1601×624 122 KB

However, the panels on the left lie outside of the structure instead of on the inside like I want it to. The other surfaces on the model have the panel solids on the inside, but it is just the wide stretch of panels on the left that have them outside. Is there any way to have them inside like the others?
inner outer
inner outer819×640 81.7 KB

help model.3dm (1.5 MB) skin2.gh (22.7 KB)

2

bump

3

Check curve directions and face normals by selectively baking each step and running the dir command in rhino. This will show small arrows indicating the direction of the surface or curve.you may need to flip some parts in relation to a guide