Different Fillets on Different Edges

[Gaurav_Chauhan]

Hello,

I am trying to achieve the following in grasshopper,

No. 2 has been made in Rhino and I am attempting to recreate it in grasshopper. I want the 4 smallest edges to have a fillet of 2.5 mm and after, the entire part to have a fillet of 1 mm. I have isolated the edges but not sure how to proceed from here on.

Any help would be appreciated.

Thank You

Fillet Problem.gh (30.1 KB)

[Joseph_Oster]

Fillet _2020Nov12aa.gh (41.7 KB)

[Jakinta (Jasmin Cubic)]

Or like this, more general, if you want always to fillet shortest edges by 2.5mm, the rest by 1mm…

Fillet Problem_RE.gh (32.4 KB)

[Gaurav_Chauhan]

Hello both,

Thank you for your prompt replies. This was very helpful