Good morning,
I’m trying to fillet some specific edges, but I’m going crazy, due to my limited knowledge in grasshopper.
I’m asking for help, because I managed to fillet some corners but I used a system that doesn’t allow me to modify much the initial parameters because then it generates problems regarding the selection of the corners to fillet.
I upload the file containing the fillets that came to me and the file without any fillet yet.

LAMPADA CINGHIA (82.4 KB) LAMPADA 3 senza (22.4 KB)

I believe this sort of problem occurs when the diameters of the pipes to be filleted are exactly the same.

Can you fillet them in Rhino without using GH?

1 Like