Using By Face Opening

[sketzjewel]

Hi Guys,

Anyone have successfully used the cutting by face opening component on steel beam or column?

thanks

[M.Tarabishy (Mohamed Eltarabishy)]

Hey @sketzjewel ,

So, there was a similar post a while back you may check…

Add holes in a beam through Rhino.Inside

Hi folks, I’m trying to get my head around rhinoinside currently trying to push steel beam geometry from rhino into Revit that is essentially a beam with some holes in it. I tried direct shape but it is wrought with issues of not properly coming into Revit. So I was hoping there was a way to set it up in rhinoinside whereby you specify a beam, attach holes to it using lines or parameters on the beam (basically automating Revit beam and hole creation). I’m almost certain there is a way in Rev…

[sketzjewel]

Thanks Mohamed, I will have a look onto it, cheers.