Uneven subdivision

[Tom_F]

Hi all,

I am triying to subdivide a funnel surface. As shown the proportion between upper and bottom panel seems extremmly different.
I was wondering, how to make a uneven-subdivision-surface, which retains the same UV-Proportion as shown?

Ideally it would be great if a/b = a’/b’.

Probably vary the #PlasticLength or #DynamicWeight in #kangaroo could be the way to start solve the problem?

The Gh file uploaded and thxs for hint in advanced!

uneven Subdivide-test1.gh (8.3 KB)

[magicteddy]

Hello,

In this recent thread this subject has been discused with hexagons on a revolution surface.

Hexagons on surface : Is there a tool that outputs nice hexagons?

Dear community I tried some plugins to put hexagons on a surface with a seam. I tried lunchbox, ngon. I didn’t try Paneling tool. These tools have problems or the seams (lunchbox, or too much points (polyline with 9 points for ngon plugin), not hexagons at the ends, or too much distorsion … As I need quite nice hexagons I developed a little tool 2 hours work). You just have to put the number of hexagons on a ring and say where is the seam (U or V). [image] Did I miss an existing tool ? M…

There are several solutions - two with Kangaroo at the end - I’ve modified mine based on domain mapping, to use rectangles instead.

uneven Subdivide-test1.gh (23.8 KB)