Ive been using the Bridge command to connect edges in SubD, and was having luck with it evenly spacing the subdivided lines but all of a sudden it started to clump the sub divided lines towards the middle. Any thoughts on how I can get it to to space the lines evenly again? Below is a picture of what I DONT want it to do.
Any help would be greatly appreciated.
-Matt
Hi Matt - please post a file with the objects you are testing.
-Pascal
i assume you accidentally increased the segments in the options of that command to 2 instead of 1.
increase the straightness slider to about 50 or higher, that should relax the spacing
Hey guys,
Sorry for the late reply.
It seems if I extrude perpendicular edges off the the two segments and then bridge from those, the spacing goes back to even.
Thank you for your replies.
-M
