I am quite new to Rhino and I am trying to loft a surface together but I get this message “Some, but not all of the curve end points touch.” I have done my best to check manually to try and figure out which is the problematic curve end points but I have been unsuccessful. Any advice here would help. Thank you.
itertation 2 sushi.3dm (52.8 KB)
CrvStart
and CrvEnd
can be used to mark the ends of curves, or turn on control points or edit points
To learn how to improve your models read:
To learn Rhino go through:
http://docs.mcneel.com/rhino/6/usersguide/en-us/index.htm
https://docs.mcneel.com/rhino/6/training-level1/en-us/
http://docs.mcneel.com/rhino/6/training-level1/en-us/
Also see the videos, etc available at Rhino - Learn to use Rhino