Rhino 7 grasshopper voronoi hammer pattern on a cup or chalice

[TheCyclist]

What would be the best way to patch this?

I have created several polylines based on a voronoi pattern. Each segment has a slight concavity to it to yield a scalloped form. However, I’m not sure what the best manner would be to build a surface between all of these polylines. Bonus points if you can also recommend a way to add a fillet to each arched edge so soften the form. I appreciate any input! [23_capture_01] 2018.08.23_mcneel_forum.gh (11.8 KB)