Push pull- calling set design and film prop folks

[gustojunk (Gustavo Fontana)]

Kyle, can you please tell Joshua that this request from @Holo circa 2014 it’s also a type of push-pull?

V6 wish: move, rotate and scale face with out changing the surroundings

I just want to put this on the agenda again: I wish for a move, rotate and scale option for surfaces in polysurfaces where the surrounding surfaces are only shrunk and extended, when a face is modified. Very simplified situation: If I make a box and select a face and rotate that face, then I wish for the ability to not distort the rest of the box, only extend and trim the other surfaces. I’ll make some simple illustrations if needed.

And. I know that 2014 is technically less than the legally required 10+ years of a request”s age to be taken seriously, but maybe we can graduate this one prematurely based on merit?

Thanks!

G