Problem With Closing face Mesh

Hello, Just a little question, I am having problems to close to face of an open mesh, I don´t know how to do it, I need two straight surface (one from each line) to close the open mesh.
Thank you in anticipation.

cut_mesh.gh (999 Bytes) Pie_CortadoUntitled.3dm (252.2 KB)

Something like this?


cut_mesh_re.gh (117.3 KB)

PS: If you bake the result, it would be still a bad mesh though, You could use "Mesh repair wizard"in Rhino to turn the bad mesh into a valid one.

1 Like

just perfect.
Thank you very much