Hello
I would like to convert this open mesh into a closed mesh. The shape must be exactly the same as the original.
This is all quite new to me. I do not use GH because I have no experience with GH. I also do not have much experience with Rhino.
Kind regards
Filip
Mesh.3dm (14.5 MB)
wow… you have a bit of work ahead of you here.
the goal will be to close up each piece, then overlap them to create a closed volume.
then run shrinkwrap to create a clean mesh.
here are a few videos to check out-
here is my take on closing it up.
there are some discontinuities that need addressing in a digital sculpting program like zbrush or 3d coat, but this will print as it is and you could hand finish if that’s what you need.
Mesh_kfix.3dm (17.7 MB)