Planarize control points

Please excuse, I should have explained what I meant.

You mentioned here that V5 had a Control Point-Mode that had the ability to move Control Points along their Tangent Extentions. Apparently that was changed for V6 due to the “Shallow Angle Problem” between the Tangent Extention and the next Polygon.

So my hope was to go back to the original V5 Mode and only use the Tangent Extention part from that without the need of using the TAB key.

This would pretty much solve my CP modelling needs for fast “Control Point Clean up” without any new development needed.

A dedicated CP Planarization Tool would be great, but the V5 mode would be sufficient as I usually do my CP “Clean Up” by hand anyway.

CP-Direction2