Optimize cross section; max displacement input/output do not match


I am trying to do an opticrosssec with Karamba. However the components output maximum displacement does not correspond with the desired maximum displacement. Trying to discover what went wrong I found that disabling the meshload, does result in a corresponding input/output max displacement. I would therefore like to ask what goes wrong inserting the meshload resulting into this error ?

Thank you in advance!

I grouped the essential elements in red.
QforumEdit.gh (121.6 KB)

1 Like

Hi, can you explain what the error is? Maybe please share a screenshot.
At the moment I see that that the maximum displacement in all loadcases is below the maximum allowable displacement of 30cm.