Layer panel jumping to highlighted layer

Rhino Rhino for Windows
1

Small annoyance is driving me nuts:

  1. My current drawing has ~350 layers, but I have tested this on two other files with fewer layers. It is just important to have enough layers to fully fill the layer panel to require scrolling down to see them all.
  2. One layer is always highlighted/selected in the layer panel. It’s not always the current layer, just whatever was the last layer that was selected or edited.
  3. When the mouse leaves the layer panel then returns, the selected layer will ‘jump’ into view.
  4. When I scroll down to interact with other layers, if I accidentally move my mouse outside of the layer panel, it jumps back to the selected layer disrupting my scroll.

I emailed this to support, did a little troubleshooting, but Steve Fuchs confirmed the behavior. We think it might be a feature, but I would prefer it to not have this behavior when my mouse exits or enters the panel.

1 Like
2

It’s super annoying. Look here:

1 Like