Karamba model: Could not find node at where support index 0 is attached

Grasshopper Karamba3D
1

Hi,

I am trying to assemble a model in Karamba and I am getting this error continuously. I tried every solution.

  1. Solution exception: Could not find node at (0/12944.2516681167/0) where support index 0 is attached.

I am attaching the model for reference

STRUCTURAL ANALYSIS MODEL.gh (29.8 KB)

2

Hi please share your Rhino model so that we can see the reference geometry. This error occurs when you try to define a support position on a point node that does not exist in your geometry. You can check the output of the LinetoBeam component to see if these points exist

3

Hi,

I am attaching the rhino model below for reference.

Dome - Structural Analysis Model WITH KARAMBA.3dm (115.4 KB)

4

Hi, your model is not modelled correctly, the points do not lie on your geometry.

image
image828×717 3.43 KB

you can use the pull point to make sure your nodes are sitting on the actual geometry

image
image1323×934 103 KB

STRUCTURAL ANALYSIS MODEL-mt.gh (29.2 KB)