Join beams

[Muhammad_Saqlain_Awa (Muhammad Saqlain Awan)]

Hi @Bilan_Gumus,

Have you tried the following

Curve should be C1 continous tolerance 0.1 degree error

Hi @Bilan_Gumus, You can massage the curves a bit before feeding the ‘Add Structural Beam’ component like this. [image] RiR-BeamsFromCurves.gh (200.2 KB) The component could do it automatically but I do prefer you have full control about what tolerance values are used and how the curves are converted to be valid for Revit. [image] In this case there is still pending to deal with the three closed curves you have on your input. Revit requires open curves to create beams.