Dynamic Area Generation Rhinoinside Revit

[yge742]

Hi all,

One of the most powerful tools of RiR is the ability to dynamically update a set of area plans while changing the wall locations.

I am currently doing this through extracting the geometry of walls and then extracting area boundary curves at the desired location.

I have two questions:

1. It is possible that regardless of the parameter, create a node that gets ALL the location lines of a wall

2. Snapping/Aligning an existing area boundary line to the closest location line of a wall - trying to replicate the constraint alignment process in Revit.

Thank you

[Japhy]

Hi Yge742,

To clarify…

@yge742

It is possible that regardless of the parameter, create a node that gets ALL the location lines of a wall

So one wall, you would like to know all these possible locations?

@yge742

Snapping/Aligning an existing area boundary line to the closest location line of a wall - trying to replicate the constraint alignment process in Revit.

I’m trying to picture how that would work in a case like this. It might be easier to delete and replace.

[yge742]

Hi Japhy,

Yes, the first solution is exactly what I am looking for. This tool can be used to categorize different types of walls and their area calculation locations.

Could this be implemented?

[Japhy]

All possible locations are available via the Structural Layers, other than that you would need to cycle through the location lines.