Ctrl + LC mouse + gumball used to relocate gumball but not now

Rhino
, ,
1

Hello everyone,

Yesterday I noticed a change/bug in Rh8 while trying to change the location of gumball to set a new rotation-center. In Rh7 I used to hold Ctrl then move the gumball by dragging it with holding the LC. But now it is acting like I held Ctrl and LC at the same time to extrude it.

Can you please check this issue? It was a very handy and fast action by gumball.

Thank you.
Mehrzad

2

This is not a bug. To relocate the gumball itself, you must double-click it.

1 Like
3

Thank you again for all your responds and helps. :pray: :star_struck: