Control points for polysurfaces

Rhino Rhino for Windows
1

Hi,

I have created a surface using a 2 rail sweep and am trying to see the control points to determine if they need alignment etc before I continue to work on the surface. I have tried SolidPtOn but it does not provide any controls along the middle of the surface where I need to check for consistency. I have also tried to explode it but that does not actually explode it…

Any ideas on how I might go about doing this?..

Thanks - Michael

2

Hello - Explode the polysurface and then turn on points for the individual surfaces.

-Pascal

3

Nice! thanks very much.

-Michael