BUG: moving angular dimension leaves a point behind

Rhino 7 SR10 2021-8-24

i select everything within range:


move it:

angular dimension is left behind partially:

Hi Ivan -

It’s hard to tell from the images but I was unable to reproduce leaving behind parts of an angular dimension.
-wim

schody_vyroba_final.3dm (6.5 MB)

Thanks for that file, Ivan.
I’ve put this on the list as RH-65502.
Are you able to reproduce this in a new file with just a few simple steps?
-wim

i dont remember how i did it but i suspect i used 3 points to define the angle and maybe there was some association to a point which was deleted afterwards and that could break something.

RH-65502 is fixed in Rhino 7 Service Release 11 Release Candidate