Array an object along a surface adjusting to it

[Tom_P]

… and check this forum for some similar topics, search for flowAlongSrf

What would be a good technique wrapping a cube with array of curves?

[image] CurveWrapping.3dm (158.6 KB) create your “cube” with _loft of two curves. use option SplitAtTangents = No (or other workflows to get a single surface) _unrollSrfUV (check this forum for Info on developable surfaces) construct / draw the lines in 2d on the unrolled surface. _flowAlongSrf to map them back to the “cube” (also check for _flowAlongSrf there are a few aspects to care of) hope this helps - kind regards -tom

there is also
_bend
command