I’m bumping my own thread here, but to…
- Trim a surface
- Inspect the design
- Adjust the construction surfaces
- Untrim
- Re-trim
- Inspect the design
…is such a tedious procedure in Rhino.
I’m going to do one of my terribly unfair comparisons that I’ve been trying to stay away from, but Rhino was much faster to rough out surfaces with up until this point. Now, I’m beginning to think I’m hitting the limits with Rhino and am beginning to wonder if, after all, and overall, Alias isn’t faster still?
(Then there’s the soft value of “fun”… Rhino was much more fun to work with than Alias, but the UI paper-cuts and the UI inconsistencies are beginning to wear me down.)