Surface Closest Point

[Joseph_Oster]

@Jason_Trajkovski

I am now trying to remove the surface from the inside of the holes whilst leaving the entire surface intact. Would I go about this using a solid difference component?

Split Surface. See this post, version ‘b’:

Speed up region difference component

Surface Split is WAY FASTER in this case. Srf SL is a cluster I wrote that returns the smallest and largest surface based on sum of edge lengths (which is faster than using area). [speed up_2022Oct22a] speed up_2022Oct22a.gh (46.9 KB) P.S. This is better: [speed up_2022Oct22b] speed up_2022Oct22b.gh (40.8 KB)