Orient10pt or similar wanted

Rhino Rhino for Windows
1

Hi
V5
or Orient6pt anything better than just 3pt.
I import my .obj

then another with a ruler in the scene.
Need to bring the two together to marry up.

I am placing points on a mesh, and can only do so to vertex locations, this sees my tyre not end up a good match to the target, spoiling hours of work thus far, through too simple a command.

as I turn off/on the one layer the mesh moves about so what could have been a dead match isnt.

if I had orient10pt I would get a better average.

There is no reason why Orient10pt couldnt be used, it would make best match.

How can this be best done ?

Cheers

Steve

2

Roll your own:

  1. Select your ten points.
  2. Run the command _PlaneThroughPt
  3. Rotate the plane about its axis and/or move it within its plane to get the target orientation you want.
  4. Run _Orient3Pt to align your object to three corners of the plane.
  5. Delete the plane.

HTH
Jeremy