Optimize the plane to 3D curves using Galapagos

[Joseph_Oster]

Yo, adapted from this yesterday:

Strange: Extrusion from planar curve is not planar!

The distances from the end points to a “common plane” (Plane Fit) are so small that they appear as zero in a text panel, unless the values are formatted. Some of the distances from curve control points to that “common plane” are larger. [191118-Forum_2019Nov19a] 191118-Forum_2019Nov19a.gh (22.9 KB)

Using your curves (UNFLIPPED or FLIPPED):

Findplane_2019Nov19b.gh (28.2 KB)

Galapagos isn’t necessary for this at all.