This is still a WIP project, so in the following days and weeks I will make a front splitter, an underbody streamline pane and will complete the engineering part of the DRL housing with mounting points and structural supports, which is currently only finished from outside. The front bumper is a tuni…

Thank you all for the nice words! :slight_smile: With regards to the question above, there are two main ways to create NURBS geometry on 3d scan data in Rhino without plug-in such like Mesh2Surface: Use snap to draw curves with the ! _InterpCrv command directly on the point cloud, then use some …

Thank you for this excellent video! It seems like you are achieving this through manual surface manipulation. In the case of drone capture, I have a point cloud, with the issue that ground points are not there because the drone only sees the trees, not the ground underneath. [Untitled 16.11.29] […

Pretty sure it’s a Motion R Tesla and not Mition…

Wow, thank you for pointing out that misspelling in the title! :slight_smile: Sometimes it happens…

The 3d terrain you posted above reminds me of the similar technique that “Google” used to capture 3d terrain for the Google Earth program, via capturing photos from different angles from a plane flying over the cities. Looks like it’s inevitable to have those blind spots around trees since the softw…

I actually screen recorded myself in Google Earth and turned that footage into the Point cloud, good call! Haha :wink:

Wow, this is why the geometry looked so familiar to me. :sweat_smile:

[image] Rhino_Bulgaria: Place a surface (with 4-6 control points in each direction) relatively oriented towards the normal of the mesh surface, then show its control points, select them all and run the ! _Pull command and select the scan data as the target. Rhino will pull the surface quite accu…

Another way to make a more accurate surface on 3d mesh is to rebuild the initial surface with at least 15-20 control points in each direction, then pull, then rebuild the resulting surface again to simplify it with 4-6 control points in each direction.

Motion R Tesla Model 3

Gallery Automotive

norbert_geelen February 25, 2022, 8:48am 9

Extraordinary work!

1 Like

Topic		Replies	Views
Reverse engineering: convert mesh to nurbes Rhino for Windows	59	18435	September 14, 2021
Reverse engineering in Rhino Rhino windows	76	1376	February 13, 2025
Modeling from a scan Rhino windows	83	2519	September 20, 2024
My second tantation to model a car Automotive wow	60	14920	March 22, 2021
Unfair and set-up comparisons by xNURBS XNurbs windows	27	6066	June 15, 2025

Motion R Tesla Model 3

Related topics