Lattice Slide with Dendro (remove SubD creases and add Attractors)

[inno]

regarding the removal of creases, looks like this was a very similar situation:

Seeking Solutions: Culling Polysurface Edges in Voronoi Lattice Creation

Quite the same as @inno but I uses closest point on curve, then sort the distance, and if the shortest is too close, it is not 100% but not far. I didn’t use the lines because you lost some precision and the tool will worse. I don’t really understand why you use this as you want some 3d smooth output!!! And as you use points in Dendro I am not sure it is useful to filter curves by length or duplicate. [image] Voronoi lattice help_LD.gh (112.5 KB)