Is it even possible in Kangaroo?

[jahuol8]

Hello, I am trying to reproduce the image (hair in the wind) shown below:

So far, I’ve managed to reach this with Kangaroo:

But I’m not satisfied, because I create the fabric in the wind with the collider and after that I extract the ‘section curves’ instead of simulating only the curves in the wind hitting the collider.

and then I only get a few curves, and I need a high density of curves as in the reference image. So I have to repeat the generation many times.

Is there a better/smarter/quicker way to simulate hair in the wind using a collider?
Wind_collider.gh (36.3 KB)

[Joseph_Oster]

DUPLICATE THREAD

Curves on Wind simulation with Collision

I’m trying to recreate this picture. [6832523.546eabbe29338] Attempt 1: I’ve been trying to use fields to move the points away from the blue area, but some curves are still crossing through it. I’m aiming to have the curves consistently avoid the blue area without intersecting it. (for simplification, now the collider is a blue area. After succeeding, then I will change it to a text). [image] collide.gh (16.9 KB) Attempt 2: Then I tried using Kangaroo to simulate a chain colliding with th…