How to hold sharp corner boundary with meshmachine?

(Joseph Vicars) #1

I am remeshing and trying to hold a boundary.
meshmachine works really well except at this sharp corner I cannot figure out how to get the triangles to stay sharp in the area circled in purple. Any help appreciated,
Joe V. (180.4 KB)

(Daniel Piker) #2

You can add an extra line to FixC, and its end points to FixV

(Joseph Vicars) #3

Thanks for your reply Daniel.
I tried that but this is the result I get.
Thoughts? (179.1 KB)

(Daniel Piker) #4

Your line needs to start and end on a vertex of the input mesh. You’ll also have to flip the reset toggle off and back on to apply this change.

(Joseph Vicars) #5

Thanks Daniel!
I was pulling the mesh edge off of the wrong mesh (before the split)