How to connect to surfaces along the edge?

Hi everyone!

I have one question, how can i connect all these layouts along the marked edges - so the area or length of the edge wouldnt change. This are the material layouts of the boat hull and I would like to make reverse engineering so i can make a 3d to render it.


Boat_hull_3d.3dm (203.0 KB)

Most common way is by using Loft or Sweep2 comands u can also try BlenSrf - so there are many options.

This topic was discussed recently here: Does anyone know a good method to un- or reverse- develop plates? Rhino 5, Rhino 6

Thank you very much!