Hex Balloons - Surface Morph Problems


I am trying to use the surface morph tool but the surface I am trying to morph back onto a surface I have revolved is not coming through properly. I cant figure out what I should have the W parameter set to in the surface morph component, this is where I am guessing I am going wrong but I am not sure.

Hex Balloons Problem.gh (23.7 KB)

Any help would be awesome! Im not sure if this is the best way to try to accomplish the hexagonal balloon or scallops. Wasnt sure if lunchbox would have been an easier way to develop a hex grid?

Any ideas? :smiley: