Create Wall along elliptical curve

[Quickly23]

Hi,

Im trying to create a wall along a section of an elliptical curve.

For some reason the wall component doesnt use the correct part (shown in green) of the curve?

Also, ideally I’d like to offset my curve but then the wall tool doesn’t
Wall.gh (12.4 KB)
seem to work at all.

Any idea why?

Many thanks,

Stephan

[Japhy]

Note that when placing a Elliptical Wall via the Revit UI it breaks into 2 halves, you’re Rhino Curves will need to be similar.

The Wall by Curve component requires Lines, Arcs or Elliptical Curves, once you offset it is no longer a considered an ellliptical curve.