3d Print on stretched textile simulation on Kangaroo

Hello,
I am trying to simulate the behaviour of stretched textile and 3d printed pattern on it.I have already tried it physically but i would like to see the result forehand. To simulate this behaviour, first i added ‘rod’ and ‘edge lengths’ components to textile mesh. So it shows the elasticty of textile. Then, i added an offseted geometry arounda the textile and i applied gravity force to this geometry. When i run the code, it gives me a simulation but the main problem, the simulation doesnt change depends on the offsetted area width.
I will be appreciate if you can check my code and help!
Here are some photos of my physical experience:



STRETCHED-TEXTILE_5.gh (25.1 KB)

It’s been done before!

https://discourse.mcneel.com/t/simulating-a-3d-print-over-stretched-fabric-effect/124024