2d continuous coral pattern by deforming a circle

[LeadBlaster420 (LB420)]

Hi how does one make a 2d continuous coral pattern like this by deforming a circle.

[laurent_delrieu]

Hello
look here

Single line continuous Art

Fun (continuous) thread all Kangaroo’s ImageCircles component takes a coloured mesh as input, which can be something 3 dimensional, so can be used for this: [image] colour_curve.gh (116.8 KB) This one starts with all the points existing from the beginning, and gradually increases the radius multiplier. More efficient is to start with only a few points and divide curves when they get above a certain length, but that currently needs to be scripted like shown in this example. I…

How do i make something like this on grasshopper?

[Screenshot 2023-10-07 130331]

this could also work, but it is not a growth

Pseudo TSP : The Great Wave off Kanagawa by Hokusai (~1829)

[theWaveTSP] [image] The The Great Wave off Kanagawa made with my tool to populate an image with circles then application of some pseudo TSP. Here there are 59083 points and the calculation time is ~4 minutes Image from The Great Wave off Kanagawa LONG.gh (9.4 KB) And now with the dual mesh [great wave dual mesh 2 min] [details] [great wave dual mesh GH script]

Adding some noise

And it is always good to give credits
From Simplexio

Simplexio | Bucharest

Programmed Deformation V2.0 Rhino + Grasshopper Workshop focusing on...

[LeadBlaster420 (LB420)]

Thankyou!
Ill thank and credit Simplexio for sure after the tattoo is done I promise.