Rhino Mac units stuck


#1

Hi All,

I have a model that is in Microns. I though it was in millimeters when I began working on it. For some reason, it is not possible to switch the units from microns to mm. It reverts when attempting to choose mm.


(Dan Belcher) #5

Hi @TemK

Sorry for the delayed reply. I’m unable to reproduce this issue in the latest RhinoWIP (5E397w). Can you please give it a try there and see if the behavior persists?


#6

I managed to get around the problem by saving a copy and then changing the units on the copy.