Push pull- calling set design and film prop folks

So are only film prop people allowed to comment on push pull (or perhaps there’s a different thread for us plebs)? :slightly_smiling_face:

I was curious if it would work on this now, but I’m suspecting that it can’t move fillets automatically? (And before you say “parametric”, it’s not in the traditional sense. This is what Siemens calls “synchronous” modeling, and I’m doing it straight on the imported models from Rhino and it can still move the fillets without issue and even resize them.)

But at least I hope it no longer shrinks surfaces? (And I’m also hoping that you won’t explicitly have to enable the command, and all improvements seen here are “backported” to the gizmo.)