Paneling a SubD geometry

Hello everyone! I am fairly new to the grasshopper. This question might be asked but i couldn’t find it in the forum.

So i have a SubD shape as in the image; (I can use a Nurbs version as well)
1
2

i am trying to panel the shape with lunchbox but the problem is that i have to explode the polysurface since lunchbox paneling demands a surface. In this case the UV grid gets applied to each surface one by one.

Is there a way to panel the polysurface with somewhat similar sized grids?


I am trying to achieve splitted surfaces similar to this essentially.

Here’s the script so far.
surface paneling with multiple attractor curves_points.3dm (202.2 KB)
surface paneling with multiple attractor curves_points.gh (14.5 KB)

I’m not sure if this is what you’re looking for. I “reverse engineered” your brep into a surface, probably with some slight inaccuracy. Lunchbox Diamond Grid seemed to work but then I realized that some of the triangles were infinitesimal. The NGon plugin has Diamond and Quad grid components that result in meshes and look much better in this case, also without the nasty seam problems.


surface paneling with multiple attractor curves_points-b.gh (48.0 KB)