Hi, There is an option in Solidworks called “full round fillet” and it fillets a nice round shape and the edge. In the following polysurface I want to do the same in Rhino. Please guide me. Thanks. Untitled.3dm (2.2 MB)

The problem is that for a full round fillet (0.25mm), the holes are too close together vertically - less than 0.5mm - so the fillets will overlap. Rhino will not do a good job on this as it does not know how to trim the neighboring fillets to each other at the points that overlap. If you use a sma…

you have an option to use BlendSrf. for this delete the inner boundaries again and click them all through in repeat mode meaning with * infront of BlendSrf or with the command repeat. i made a few of those with tangency. it involves some manual work because all holes seem a little different, otherwi…

RichardZ: you have an option to use BlendSrf. That will, of course, change the hole inner diameter… --Mitch

[image] Helvetosaur: That will, of course, change the hole inner diameter no :scream: well as you discovered yourself, a full round fillet creates a lot of mess and naked edges and since i could not find any reference for this to be a constraint :wink: blend surface is his option. another op…

[image] Cyver: A good example where the V6 FaceEdges selection is really useful, can do all fillets/Chamfers in 3 Clicks. Can you please explain a bit? I don’t understand what you mean by “FaceEdges selection”. Thank you.

In V6 , when you run Fillet/ Chamfer/Blend egde , in command bar you have an option to select each borders of a face “FaceEdges” , just click on that , then select faces you want. [2017-12-11_16-06-42]

[image] Cyver: In V6 , when you run Fillet/ Chamfer/Blend egde , in command bar you have an option to select each borders of a face “FaceEdges” , just click on that , then select faces you want. Thank you Cyver for the hint. @Pascal @margaret A listing of all these hidden enhancements wo…

How to fillet the following holes in full round?

Rhino Rhino for Windows

Cyver December 10, 2017, 9:36am 6

A good example where the V6 FaceEdges selection is really useful, can do all fillets/Chamfers in 3 Clicks.

Topic		Replies	Views
Full round fillet? fillet tan, tan, tan? Serengeti (Rhino WIP) windows	1	404	June 4, 2021
Filleting bugs in Rhino Serengeti (Rhino WIP)	21	4791	January 28, 2017
Simple shape wingnut and FilletEdge small enough to suit yet fails Rhino for Windows windows	11	549	May 17, 2021
Problem using fillet edge or workflow around it Rhino for Mac	9	3217	October 4, 2017
`BlendSrf` or equivalent along this edge? Rhino mac	3	133	December 30, 2024

How to fillet the following holes in full round?

Related topics