Good morning all,
i can’t switch a rhino cube to revit with rhino inside, i don’t understand how? the cube is made on rhino 7, and i want to make it passed to volume category on revit, do you have any examples of grasshopper file type i should do?
thx,
Erwan
Rickson
(Rickson)
February 5, 2021, 2:25pm
3
If you add a form to a family it will report its volume via system parameter.
If you are referring to spatial elements they have a guide of what’s currently available in RiR
https://www.rhino3d.com/inside/revit/beta/guides/revit-spatial
no i want to create a cube with rhino and then put the cube in revit with a volume property in its category…
Rickson
(Rickson)
February 5, 2021, 2:50pm
5
can you show an example of some sort? Not quite following.
Here is a cube, put into a family as a Form which reports its volume.
Rickson
(Rickson)
February 5, 2021, 2:51pm
6
Here is a list of all categories in revit, i don’t see volume.
I didn’t see this listed out anywhere online yet, so here it is: AdaptivePoints AdaptivePoints_HiddenLines AdaptivePoints_Lines AdaptivePoints_Planes AdaptivePoints_Points AlwaysExcludedInAllViews Analemma AnalysisDisplayStyle ...
Reading time: 4 mins 🕑
Likes: 6 ❤
I can’t finish the grasshopper file to have the brep in revit with volume as the category
Rickson
(Rickson)
February 5, 2021, 4:08pm
8
What discipline are you in?
Rickson
(Rickson)
February 5, 2021, 4:36pm
10
So you are in the Architectural Discipline. What language? I believe its a translation issue: regardless, you can set the category per the example above.
https://www.rhino3d.com/inside/revit/beta/guides/
i am French so after the grasshopper ,What do I do to finish the file?
yes i am french and architecte and i want to create to my volume and i want to create stress and rib with gross area