Gridshell Lattuce in Rhino/Grasshopper


I was hoping to get some advice on how to approach creating a grid shell lettuce using a
grasshopper. I’m still very new to the software so, unfortunately, a “little” learning curve. I’ve established the vertical elements and want to create parametric horizontal supports similar to the picture below. I was hoping I could use the divided line points to shape the horizontal braces similar to how the upright ones are constructed, but frankly, I’m not sure where to take it from here. Any help is greatly appreciated!

Grid (8.6 KB)

Grid (11.5 KB)

Thank you very much! So by specifying (+1,1) and (-1,+1) separate the meeting points so they can be specified by the following line command?