Executing Set of Planes to Multiple Curves Data Lists

Grasshopper
, ,
1

Greetings, everyone!

I am currently working on dividing the curves of three blocks using a set of planes positioned at the base of each block (please refer to the first image). However, as illustrated in the second image executing the “Curve | Plane” component is not working properly.

BASE PLANES
BASE PLANES1716×671 197 KB

OPTION 01
OPTION 011789×863 120 KB

To ensure consistency in the division of the curves, I attempted to duplicate the planes based on the heights of the floors. However, this approach also did not work (please refer to the attached image below).

OPTION 02
OPTION 021815×897 130 KB

All curves are internalized in the GH file.
I would greatly appreciate any suggestions or ideas to resolve this issue.

Thank you in advance.
CURVE-PLANES.gh (32.2 KB)

2

It’s been a while since I’ve touted the power of Graft Parallel !

image
image1916×756 181 KB

CURVE-PLANES.gh (22.6 KB)

2 Likes
3

Thank you very much, it is working perfectly now. Great to learn about the Graft Parallel component as well.