Hi I was wondering if it is possible to cut a surface like the following picture (along the yellow and orange lines) but the torus remain same visually, just like there are seams? But when I use a surface to cut the torus, it extended the surface and cut the part it shouldn’t be cut. I was wondering…

Cut surface in grasshopper/rhino

Joseph_Oster February 13, 2024, 8:08pm 11

Ten posts so far and you still haven’t posted any code?

3. Attach minimal versions of all the relevant files

1 Like

Topic		Replies	Views
Cutting surface Grasshopper windows , surface , curves , tube	2	164	May 15, 2024
Surface Split / Cut Surface from Curve Grasshopper curve , grasshopper , surface	3	9404	May 15, 2018
Surface split gives rounded edges instead of sharp.(later extract smaller surfaces) Grasshopper split , surface	2	560	April 25, 2020
Edges are split after trimming a surface Rhino Developer windows	0	25	August 8, 2024
Split Surface did not cut everything Grasshopper windows	4	659	January 19, 2021