Control Spacing of circles in Hex Grid

So you don’t need Map Srf at all. That’s what I figured… :man_facepalming:


CPP1 7-15_2019Jul15c.gh (30.3 KB)

P.S. I didn’t actually cut the holes in the surface but you have three options:

  1. Boundary Surface using the perimeter curve and circles; this is often the best option for planar surfaces, but will be extremely slow for ~14,000 circles in this case!.
  2. SrfSpilt is probably even slower. Both might fail before they finish.
  3. Bake the surface and circles to Rhino and cut the holes there.

I already mentioned this old thread in your duplicate thread:

Some of it is irrelevant for planar surfaces but there is a discussion of option #3 (bake and cut in Rhino) showing it can be MUCH FASTER than Grasshopper.

Oh, there is a fourth option: cut holes in a panel that is ~1/10th the size (1/10th the number of holes!) and then copy/move it nine times.