I’m trying to cap both sides of my surface. I used patch and when I look very close to it’s margin, the patch geometry’s margins are slightly not on the same line as my shape margin is. Can you have a look and tell me how to achieve it? What to select when creating cap? curves, or shape? After cr…

I'm trying this for one hr and still no result :(

menno (Menno Deij - van Rijswijk) January 14, 2015, 12:51pm 5

– changed category to Rhino for Windows —

How to weld meshes?

Topic		Replies	Views
How would you cap irregular profiles with a hemisphere? Rhino windows	14	1009	December 31, 2021
How to create a rounded cap? Rhino for Windows	2	12690	May 16, 2014
Create a rounded cap following this blended curve Rhino for Windows windows	1	68	February 24, 2025
Create a round cap with continuous surface geometry Rhino for Windows networksurface	8	1283	September 30, 2020
Beginner problem with surfaces (signet) Rhino for Windows	10	3827	September 20, 2015