Zebra stripes problem ;-;

[Gears_Gears]

Hi! May I get a second pair of eyes on the following Zebra Stripes situation? It looks like the surface has problem (zigzags along the ‘pointy’ parts of the surface). I cranked up the mesh setting to pretty high but this problem persists. (internalized geometry in attached)

Is this surface just bad curvature? I created it with u and v curves for network surface

Thanks a lot!
wobbly_zebra.gh (241.5 KB)

[Gears_Gears]

in this picture, this happen at the bottom. it’s very bizarre

[dale (Dale Fugier)]

Hi @Gears_Gears,

If you are looking at a baked version using Zebra, try cranking up the mesh density (DocumentProperties > Mesh).

– Dale

[Gears_Gears]

Thank you!