Sweep1 fails where extrude along doesn't but orientation wrong

[inno]

please drag your gh file into the textbox where you write messages, give it a few seconds to upload succesfully, then post it

be sure to have internalized geometries if necessary, here is how to do that:

@DavidRutten

3. Attach minimal versions of all the relevant files
If you have a gh file you have a question about, attach it to the post. Do not expect that people will recreate a file based on a screen-shot because that’s a lot of pointless work. It’s also a good idea to remove everything non-essential from a gh file. You can use the Internalise Data menu option to cut everything to the left of a parameter:

Simplifying a Grasshopper network

If you are referencing curves or breps or meshes from Rhino, you can also internalise them so you won’t have to post a 3dm file as well as a gh file. If you’re unsure whether all the relevant data is internal to the gh file, try opening it in an empty Rhino. Does it work? Good. No? You’ll need to internalise more.