Hi guys,
I’m struggling to figure out how I should I approach this particular problem. I have a curbed and rotated surface that has been split in to 24 parts. I want to create a glass facade that follows similar to the image below.
Any help on this would be greatly appreciated.
SAVE 1 [Oct-23 '23, 2317].gh (106.1 KB)
Sure!.. But we are going to need a gh file. 
Have now attached it, sorry about that is my first post on the forum, so I’m quite new to it all.
@Jason_Osborne
Here is a shot at it if I understand your question right.
SAVE 1 [Oct-23 '23, 2317] Shot.gh (112.8 KB)
I appreciate the help, and apologise because I should’ve been clearer. I was specifically trying to make the glass staggered, and not follow the curve exactly. See rough sketch below.
Thanks,
Thank you so much, you’re a legend.
if this is working how are u goanna fix the inner frame that match both sides of the glass am curious to know about it
regards
rajeev
