Seeking, Rhino6, Control Point Loft (CPLoft) this battery, I want to run in Rhino5

双轨多切面.gh (992.4 KB)

Control Point Loft is a native component in Grasshopper 1.0.0007.
If you are using Rhino 6 you can find it here:

I know but I want to use it in Rhino 5. . Currently in Rhino6 than Rhino5 card (30.6 KB)

I have already known this method, some surfaces can not be staked, such as (32.7 KB)

I know it can be like this, but the deformation is too big, no Rhino6 tool is good, no need to reduce points, can stake out